Outdoor Survival Info

Archive for October, 2008

If you install a scope on your Marlin 336 rifle, you will probably need to install the included hammer spur. The Marlin 336 comes with a hammer spur, and it’s really easy to install. If your Marlin rifle didn’t come with one, or if you lost your spur, just contact your local gun shop to order one for you.

Here is what came with my rifle:

See the little red thing on the end of the allen wrench? That’s the screw that will hold your hammer spur in place. It does an OK job, but if you work the hammer a lot, you might need to re-tighten it. To install, you just slide the spur on the hammer as far as it will go. There are two little grooves on the side of hammer, so the spur will stop when it gets there. Do this next:

Just tighten it up nice and snug, and then remove the allen wrench. Simple. Make sure it’s tight, but not so tight that you break the allen wrench. Here’s what you get when you’re done:

Some things to keep in mind: You might not need it, and you might need to tighten it from time to time.

Remember, this spur might come loose. Just keep the allen wrench handy for re-tightening, or contact your gunsmith for some kind of firearm adhesive (locktite or similar…talk to a professional).

When I say that you might not need it, you’ll just have to look at you and your setup to see if you can do without it. I have a 50mm scope, so I have the tall scope mounts for the clearance. I also have average-sized thumbs. So there’s plenty of room to work the hammer without the spur. I’ve tried it several times, and it just works out. If there is any question about your ability to work the hammer, stick with the hammer spur. Don’t risk an accident!

The installation only takes a few second, so go ahead and put it on there. Besides it’s obvious benefit for scopes, the hammer spur will also help out when removing the action for cleaning. But I won’t show you that here. Next time I’ll write a little how-to article for stripping your Marlin 336 for cleaning. Don’t worry, that’s easy, too. Subscribe to the RSS feed or the email newsletter to get notice of it.

Here is a how-to great article about recycling an old circular saw blade into a nice guthook knife. Use it for hunting, toss it your bug out bag… Read the article here:

How to Make a Guthook Knife from an Old Saw Blade

I’ve got my scope mounted on my weaver base, and I’m ready to bore sight. I think I’ll pick up a laser bore sighter and use that to get the scope set up initially. Then I’ll work on zeroing it.

I’m really looking forward to some pin-point accuracy with such a fun and functional rifle. I’ll need to do this all within the next few weeks, as modern gun deer season starts soon. I’m going to scout some in the woods this weekend while squirrel hunting. Hopefully I’ll see some good deer sign. Maybe they haven’t moved very far from where they were last year.

I hope that this season is better than last year. The weather was so screwed up, I don’t think the deer knew what to do with themselves. It would be a shame if I didn’t even get to test this rifle out in the field because everything is screwy again this year. Here’s to hoping for the best…